Singing in the bathtub!

Well the weather is still cold here so I still have not had a chance to sand anything outside.

So I took some time today to wash up my resin parts and get some of the mold release off.

I did an ok job and will wash them again later just to make sure.

I also etched the resin on my flasher housings so I could mount the electronics I bought from http://fiberopticproducts.com/ . They were only $9.00 each and already put together! I then used a hot glue gun to glue the back of the board to the flasher housing.

I also order from the run of power distribution boards, run #3. These boards are used to step down voltage from 12 volt batteries. More on them later when I get mine.