This evening the weather was finally warm and I worked on R2 outside for the first time.
I cut some extra square 1 inch wood that I bought to make skirt ribs with and used it to finish making the holders for the batteries. My center leg blocks were a little long so I had to cut them.
I then chiseled out the left over glue
The 1 inch stock slides snugly into place and the rear hold down will keep pressure on it so it will not move. Next I centered the outer legs and made sure they were parallel and square to the frame and each other and drilled some holes in the pipes. I then bolted the legs together and now they act as one. :)